Skip to main content

Turner Test


Turner August Test Quiz

  1. The depth of cut is given by

    2. the top slide
    the cross-slide
    the compound slide
    adjusting the tool

  2. B.I.S. means

    3. Bureau of Indian Standards
    Board of International System
    Bureau of Standard Institution
    Board of Indian Standard

  3. The most important quality of any cutting fluid is

    4. emulsification
    specific heat
    specific gravity
    viscosity

  4. By using coolants on workpieces we can choose

    5. higher cutting speeds
    lower cutting feeds
    lower cutting speeds
    heavy depth of cuts

  5. The Centre drill size is selected on the basis of the

    6. length of the job
    material of the job
    diameter of the job
    type of operation

  6. Centre drilling is done at a

    7. high spindle speed with a high feed
    low spindle speed with a high feed
    high spindle speed with a low feed
    low spindle speed with a low feed

  7. Knurling operation is done at the

    8. turning spindle speed
    high spindle speed
    1/3 of the turning spindle speed
    1⁄2 of the turning spindle speed

  8. Knurling is the operation of

    9. shearing
    forming
    turning
    pressing

  9. The least count of vernier caliper is

    10. 0.01 mm
    0.02mm
    0.001 mm
    0.2 mm

  10. A tumbler gear unit has

    11. a single gear
    two gears
    three gears
    four gears

  11. The parting off operation must be carried out at

    12. a high spindle speed
    automatic feed
    a reduced spindle speed
    a variable spindle speed

  12. Catch plates usually have

    13. T-slots
    T-slots and straight slots
    one single slot
    one or several slots

  13. Driving plates are used for

    14. mounting fixtures and workpieces
    driving shafts between Centre’s with a lathe dog
    facing operations only
    internal operations only

  14. The half-nut lever is used for

    15. engaging the longitudinal feed on the
    taking up the slack in the cross-slide nut
    changing from longitudinal to cross-feed
    threads cutting

  15. For mounting a lathe chuck

    16. start it by hand and then turn the power on
    mount it on by power
    mount it by hand
    mount it with the help of a hammer

Comments

Post a Comment